Auto tools shield wire&quot

How to Install Strobe Lights in Headlights 1Disconnect your auto battery.2Mark the place where you'd prefer to set up your strobe lights. It's essential to install strobe lights at or below the horizontal center line of the reflector. Moreover, you must leave a minimum of 1 inch of space among the strobe light along with the lens, and also you ought to not install the strobe light above the manufacturer-installed light Auto tools.3Remove the reflector assembly out of your headlights.

Use the socket wrench to eliminate the retaining bolts then lift the reflector assembly from the mounting bracket.4Use a hole saw to cut a 1-inch hole within the headlight housing.5Attach the thermal disc that came with your strobe lights towards the strobe light bulbs. Do this by aligning the disc holes together with the lamp ears and snapping them into location.6Insert the disc/strobe light assembly in to the hole inside your headlight housing. Use the hardware supplied by the manufacturer to secure the strobe lights to your headlight housing.7Connect the strobe light assembly for the 3-socket connector housing. Connect the 3-socket connector housing to a 3-conductor power cable, with red, black, and white wires corresponding to negative Auto diagnostics, good and ground charge respectively. Insert the red wire in to the initial socket on the 3-socket connector, labeled "1," the black wire in to the second socket, labeled "2," as well as the white wire in to the third socket, labeled "3."

You may also notice "shield wire" on every side of the 3-conductor energy cable. The shield wire prevents electromagnetic interference (interference from radio or communication sources). Use wire cutters to cut the shield wire, to ensure that it is flush with all the cable jacket.8Connect the 3-conductor energy cable towards the 3-pin energy housing that runs for the vehicle battery. Connect the red pin into the 1st connection of the 3-pin power housing, the black pin in to the second connection, plus the white pin into the third connection. In case you are in an location where radio interference is often a problem then you will need to ground to the chassis the shield wire located on the side of your power cable adjacent to the energy housing. You can attach it to the chassis working with electrical tape.9Connect the power housing to the terminals of your car or truck battery.10Replace the reflector covering more than your strobe lights. You happen to be now prepared to operate your strobe lights.